Figure 11-23 Cam Bracket Assembly - Xerox Phaser 7700 Service Manual

RRP 81 Cam Bracket Assembly

Figure 11-23 Cam Bracket Assembly

Removal
1. Remove the Rear and Top Covers (RRP 72, on page 308).
2. Remove one screw securing the Decurler Cam Sensor.
3. Remove one screw from the Eject Clamp Home Sensor.
4. Disconnect the wiring harness from the Set Clamp Home Sensor.
5. Remove the wiring harness from the bracket.
6. Disconnect the wiring harness from the Eject Motor.
7. Remove four screws from the bracket and remove the Cam Bracket Assembly.
Note When reinstalling the Cam Bracket Assembly the manipulate the
Eject Assembly to ensure the gears follow one another from the
back of the Cam Bracket Assembly. Manually push the set clamps
to engage the gears.
Service Quick Reference Guide - Finisher
11-319