Xerox Phaser 7700 Supplementary Manual

Getting

Print Quality

All trays in the printer require a paper setting. The default is laser paper, 60-90 g/m
load any other paper weight or type, you must set that new paper at the front panel. Printing with the wrong
setting can cause print-quality problems or damage the fuser.

Load trays with the correct weights

MPT
60 g/m 2 – 220 g/m 2
16 – 28 lb. bond
50 – 80lb. cover
100 – 110 lb. index
Tray 1
60 g/m 2 – 169 g/m
16 – 40 lb. bond
50 – 60 lb. cover
65 – 90 lb. index
Tray 2, 3, 4
60 g/m 2 – 105 g/m
16 – 28 lb. bond
Tray 2
60 g/m 2 – 105 g/m
16 – 28 lb. bond
Tray 3, 4
75 g/m 2 – 105 g/m
20 – 28 lb. bond
Use only Xerox Do not use glossy
Phaser ® 7700 inkjet paper, or
non-laser glossy
transparency film.
paper. Fuser damage
may result.
Best
the
2 (16-24 lb. bond). If you

Check the Paper Tips Page

For detailed information on supported papers, weights,
and front panel settings print the built-in Paper Tips
Page
PHASER 7700
READY TO PRINT
Xxxxxxx
Printable Pages
Xxxxx Xxxxxxxxx
Xxxxxxxxx
1
Scroll to
2
"Printable Pages"
2
Press "OK"
2
Printable Pages
Xxxxxxx Xxxxxxxx
Print Paper Tips Page
Xxxxxxxxx Xxxxxxx
Xxxxxxxx Xxxxxxxxxxx
3
Scroll to
"Print Paper Tips Page"
2
4
Press "OK"
2

Print the Menu Map

More help pages and diagnostic procedures are listed on
the printer's Menu Map under the Printable Pages
Menu.
At the Front Panel:
1
Scroll to
"Printable Pages"
2
Press "OK"
3
Scroll to
"Print Menu Map"
4
Press "OK"

Front panel buttons

Up Arrow
OK
Cancel
Printing
Information
Back
Down Arrow

Calibrate colors

Color balance can be tuned at the printer's front panel by
following the procedure outlined on the Tutorial Page.
Highlight, mid-tone, and shadow adjustments can be
made.

Calibrate for paper

To tune your printer for a particular brand or grade of
paper follow the steps on the Calibrate for Paper Pages.
This may also be necessary if the temperature or
humidity changes significantly.

PhaserSMART

TM
PhaserSMART is an automated printer diagnostic and
troubleshooting tool that uses your internet connection and a
web browser.
To access PhaserSMART via the web: go to www.phaserSMART.com, and
then enter your printer's IP address.
To launch PhaserSMART fromCentreWare IS: From a web browser, enter
your printer's IP address. Select Support. Select the Technical Support link
to access PhaserSMART.
To launch PhaserSMART from a Windows computer: From your Phaser
7700 printer driver Properties dialog box, select the Troubleshooting tab.
Select the Technical Support web link. www.PhaserSMART.xerox.com