RRP 25 Dispense Assembly
Figure 7-26 Dispense Assembly
Removal
Note
After replacing the Print Cartridge Plate Assembly, you must
perform the RegiCon adjustment to the printer ,on page 4-117.
Caution
Use only a type II toner vacuum to clean up toner spills.
Note
Have a large sheet of newspaper or something similar available to
place the removed assemblies on.
Note
The dispense assemblies overlap and must be removed in the
following order: Y - M - C - K, then reinstalled K - C - M - Y.
1.
Open the Front Door.
2.
Remove the print cartridges as necessary.
Note
Cover the exposed opening with a wide piece of tape to avoid
spillage. Do not overlap the tape to the base plate located behind
the opening
3.
Remove the print cartridge plate cover (RRP 24, on page 7-165)
4.
Leave the main lever down.
5.
Pull the shut off gate of each toner cartridge toward you (approximately 3/4"
[or 20mm]) to shut off the toner supply for each toner tube (see Figure 7-26,
"Dispense Assembly," on page 7-166).
7-166
Phaser 7700 Color Laser Printer
.