RRP 40 Internal Hard Drive
Fig. 1
Fig. 2
Figure 7-43 Internal Hard Drive
Caution
The Internal Hard Drive is susceptible to ESD damage. Observe
proper ESD procedures.
1.
Remove the Image Processor Board. See (RRP 39, on page 7-186).
2.
Using a T-10 torx bit, remove four screws on the bottom side of the Image
Processor Board holding the Internal Hard Drive.
3.
Slide the Internal Hard Drive away from the connector.
Note
It is possible to mis-align the pins when seating the new Internal
Hard Drive.
Caution
If you replace the Internal Hard Drive, you must enter Service
Diagnostics Mode and run the "Store NVRAM" test.
Service Quick Reference Guide - Removal & Replacement Procedures
S7700-434
7-187