RRP 81 Cam Bracket Assembly
Figure 11-23 Cam Bracket Assembly
Removal
1.
Remove the Rear and Top Covers (RRP 72, on page 11-330).
2.
Remove one screw securing the Decurler Cam Sensor.
3.
Remove one screw from the Eject Clamp Home Sensor.
4.
Disconnect the wiring harness from the Set Clamp Home Sensor.
5.
Remove the wiring harness from the bracket.
6.
Disconnect the wiring harness from the Eject Motor.
7.
Remove four screws from the bracket and remove the Cam Bracket
Assembly.
Note
When reinstalling the Cam Bracket Assembly the
manipulate the Eject Assembly to ensure the gears
follow one another from the back of the Cam Bracket
Assembly. Manually push the set clamps to engage the
gears.
Phaser 7700 Color Laser Printer Service Manual
11-341