Rep 9.6 Dispenser Cover (Imaging Unit Plate Cover); Rep 9.7 Toner Dispenser (Dispense Assembly) - Xerox Phaser 7760 Service Manual

REP 9.6 Dispenser Cover (Imaging Unit Plate Cover)

Parts List on PL 10.2
Removal
1. Open the Front Door.
2. Open the Left Cover Assembly (Left-Hand Door A).
3. Remove the Fuser Cover (REP 14.8).
4. Slide the 4 Imaging Units out lightly.
5. Release and move the IBT Cam Lever half way down.
6. Remove the 4 screws and remove the Dispense Cover
Figure 1 Removing Dispenser Cover
Revised
Phaser 7760 Color Laser Printer

REP 9.7 Toner Dispenser (Dispense Assembly)

Parts List on
Removal
NOTE: Use only a type II Toner Vacuum to clean up toner spills. Have a drop cloth available to
place the removed assemblies on.
The Dispense Assemblies overlap and must be removed in the following order: Y - M - C - K,
then reinstalled as K - C - M - Y.
(Figure 1).
1.
2.
3.
4.
5.
6.
January 2010
4-39
PL 6.1
CAUTION
Open the Front Door.
Remove the Waste Toner Cartridge.
Remove the Imaging Units if necessary.
Remove the Toner Cartridges.
Remove the Imaging Unit Plate Cover (REP
Removing the Toner Dispenser.
a. Cover the exposed opening with a wide piece of tape to avoid spillage
NOTE: The tape will not stick unless all toner is cleaned off the dispenser first. Do
not overlap the tape to the base plate located behind the opening.
b. Beginning with the Yellow Toner Dispenser, remove the screw securing each Dis-
pense Assembly to the Printer (Figure
Figure 1 Removing Toner Dispenser
9.6). Leave the Main Level down.
(Figure 1).
1).
Repairs and Adjustments
REP 9.6, REP 9.7