Mvr Vlan Group - Edge-Core ES3510MA Management Manual

This command statically binds a multicast group to a port which will receive

mvr vlan group

long-term multicast streams associated with a stable set of hosts. Use the
no form to restore the default settings.
S
YNTAX
[no] mvr vlan vlan-id group ip-address
D
EFAULT
No receiver port is a member of any configured multicast group.
C
OMMAND
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
◆ Multicast groups can be statically assigned to a receiver port using this
command.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for
◆
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
IGMP snooping must be enabled to a allow a subscriber to dynamically
◆
join or leave an MVR group (see the
that only IGMP version 2 or 3 hosts can issue multicast join or leave
messages.
E
XAMPLE
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/7
Console(config-if)#mvr type receiver
Console(config-if)#mvr vlan 3 group 225.0.0.5
Console(config-if)#
vlan-id - Receiver VLAN to which the specified multicast traffic is
flooded. (Range: 1-4093)
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast
traffic from the IP address specified for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
S
ETTING
M
ODE
U
SAGE
– 879 –
| Multicast Filtering Commands
C 37
HAPTER
Multicast VLAN Registration
ip igmp snooping command). Note