Figure 3-21 Vlan Group Settings; Vlan Port Configuration - Edge-Core ES4308-PoE Management Manual

Web – After creating a new VLAN, the following screen displays. Assign the ports
and trunks associated with the VLAN, and click Apply.

VLAN Port Configuration

There are three different parameters that can be configured for each port on the
switch; VLAN ID (VLAN membership), PVID and Packet Type. Note that the ports
within a trunk cannot be configured individually; configure the trunk instead (trunks
are labelled T1 to T4).
Field Attributes
• Port/Trunk – The port number of the port or the ID of a trunk. This cannot be
changed.
• VLAN Aware Enabled – VLAN aware ports will strip the VLAN tag from received
frames and insert the tag in transmitted frames (except PVID). VLAN unaware
ports will not strip the tag from received frames or insert the tag in transmitted
frames.
• Packet Type – Sets the interface to accept all frame types, or only tagged frames.
If the Packet Type is set to "All," the port can accept incoming tagged and
untagged packets. Untagged packets will be associated with the VLAN identified
by the PVID. Tagged packets will be dropped unless the port is a member of the
VLAN identified by the VLAN tag in the packet.
If the Packet Type is set to "Tagged Only," the port will drop untagged packets and
will only receive tagged packets. Tagged packets will be dropped unless the port
is a member of the VLAN identified by the VLAN tag in the packet. (Default: All)

Figure 3-21 VLAN Group Settings

Web Configuration
3-23