Configuring A List Of Name Servers - Edge-Core ES3510MA Management Manual

| IP Services
C 17
HAPTER

Configuring a List of Name Servers

C L
ONFIGURING A IST OF
N S
AME ERVERS
Use the IP Service > DNS - General (Add Name Server) page to configure a
list of name servers to be tried in sequential order.
CLI R
EFERENCES
"ip name-server" on page 905
◆
◆ "show dns" on page 907
C U
OMMAND SAGE
◆ To enable DNS service on this switch, configure one or more name
servers, and enable domain lookup status (see
DNS Service Parameters" on page
When more than one name server is specified, the servers are queried
◆
in the specified sequence until a response is received, or the end of the
list is reached with no response.
If all name servers are deleted, DNS will automatically be disabled. This
◆
is done by disabling the domain lookup status.
P
ARAMETERS
These parameters are displayed:
Name Server IP Address – Specifies the address of a domain name
server to use for name-to-address resolution. Up to six IP addresses can be
added to the name server list.
W I
EB NTERFACE
To create a list name servers:
Click IP Service, DNS.
1.
Select Add Name Server from the Action list.
2.
Enter one name server at a time.
3.
Click Apply.
4.
Figure 263: Configuring a List of Name Servers for DNS
– 436 –
"Configuring General
433).