Clock Timezone - Edge-Core ES3510MA Management Manual

E
XAMPLE
Console#show sntp
Current Time
Poll Interval
Current Mode
SNTP Status
SNTP Server
Current Server : 137.92.140.80
Console#
This command sets the time zone for the switch's internal clock.

clock timezone

S
YNTAX
clock timezone name hour hours minute minutes
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT), based on
the earth's prime meridian, zero degrees longitude. To display a time
corresponding to your local time, you must indicate the number of hours
and minutes your time zone is east (before) or west (after) of UTC.
E
XAMPLE
Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
Console(config)#
R
ELATED
show sntp (542)
: Nov 5 18:51:22 2006
: 16 seconds
: Unicast
: Enabled
: 137.92.140.80 0.0.0.0 0.0.0.0
{before-utc | after-utc}
name - Name of timezone, usually an acronym. (Range: 1-30
characters)
hours - Number of hours before/after UTC. (Range: 0-12 hours
before UTC, 0-13 hours after UTC)
minutes - Number of minutes before/after UTC. (Range: 0-59
minutes)
before-utc - Sets the local time zone before (east) of UTC.
after-utc - Sets the local time zone after (west) of UTC.
S
ETTING
M
ODE
U
SAGE
C
OMMANDS
– 543 –
| System Management Commands
C 21
HAPTER
Time