Edge-Core ES3510MA Management Manual page 161

a port as forbidden to prevent the switch from automatically adding it to a
VLAN via the GVRP protocol.
CLI R
EFERENCES
"Configuring VLAN Interfaces" on page 788
◆
"Displaying VLAN Information" on page 795
◆
P
ARAMETERS
These parameters are displayed:
Edit Member by VLAN
VLAN – ID of configured VLAN (1-4093).
◆
Interface – Displays a list of ports or trunks.
◆
Port – Port Identifier. (Range: 1-10)
◆
Trunk – Trunk Identifier. (Range: 1-5)
◆
Mode – Indicates VLAN membership mode for an interface.
◆
(Default: Hybrid)
Access - Sets the port to operate as an untagged interface. The
■
port transmits and receives untagged frames on a single VLAN only.
Access mode is mutually exclusive with VLAN trunking (see
Trunking" on page
interface, then that interface cannot be set to access mode, and
vice versa.
Hybrid – Specifies a hybrid VLAN interface. The port may transmit
■
tagged or untagged frames.
1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A
■
trunk is a direct link between two switches, so the port transmits
tagged frames that identify the source VLAN. Note that frames
belonging to the port's default VLAN (i.e., associated with the PVID)
are also transmitted as tagged frames.
PVID – VLAN ID assigned to untagged frames received on the interface.
◆
(Default: 1)
When using Access mode, and an interface is assigned to a new VLAN,
its PVID is automatically set to the identifier for that VLAN. When using
Hybrid mode, the PVID for an interface can be set to any VLAN for
which it is an untagged member.
Acceptable Frame Type – Sets the interface to accept all frame
◆
types, including tagged or untagged frames, or only tagged frames.
When set to receive all frame types, any received frames that are
untagged are assigned to the default VLAN. (Options: All, Tagged;
Default: All)
– 161 –
C
HAPTER
152). If VLAN trunking is enabled on an
| VLAN Configuration
6
IEEE 802.1Q VLANs
"VLAN