Ipv6 Address - Edge-Core ES3510MA Management Manual

This command configures an IPv6 global unicast address and enables IPv6

ipv6 address

on an interface. Use the no form without any arguments to remove all IPv6
addresses from the interface, or use the no form with a specific IPv6
address to remove that address from the interface.
S
YNTAX
[no] ipv6 address ipv6-address/prefix-length
D
EFAULT
No IPv6 addresses are defined
C
OMMAND
Interface Configuration (VLAN)
C
OMMAND
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
◆
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields.
To connect to a larger network with multiple subnets, you must
◆
configure a global unicast address. This address can be manually
configured with this command, or it can be automatically configured
using the ip
◆ If a link-local address has not yet been assigned to this interface, this
command will assign the specified static global unicast address and also
dynamically generate a link-local unicast address for the interface. (The
link-local address is made with an address prefix of FE80 and a host
portion based the switch's MAC address in modified EUI-64 format.)
If a duplicate address is detected, a warning message is sent to the
◆
console.
E
XAMPLE
This example specifies a full IPv6 address and prefix length.
Console(config)#interface vlan 1
Console(config-if)#ipv6 address 2001:DB8:2222:7272::72/96
Console(config-if)#end
Console#show ipv6 interface
Vlan 1 is up
IPv6 is enable.
Link-local address:
FE80::2E0:CFF:FE00:FD/64
Global unicast address(es):
2001:DB8:2222:7272::72/96, subnet is 2001:DB8:2222:7272::/96
ipv6-address - A full IPv6 address including the network prefix and
host address bits.
prefix-length - A decimal value indicating how many contiguous bits
(from the left) of the address comprise the prefix (i.e., the network
portion of the address).
S
ETTING
M
ODE
U
SAGE
ipv6 address autoconfig
– 927 –
| IP Interface Commands
C 41
HAPTER
command.
IPv6 Interface