Show Nlm Oper-Status - Edge-Core ES3510MA Management Manual

8-port layer 2 fast ethernet switch

Hide thumbs Also See for ES3510MA:

Table of Contents

| SNMP Commands

show nlm oper-

To avoid this problem, notification logging should be configured and

enabled using the snmp-server notify-filter command and

command, and these commands stored in the startup configuration file.

Then when the switch reboots, SNMP traps (such as warm start) can

now be logged.

When this command is executed, a notification log is created (with the

default parameters defined in RFC 3014). Notification logging is

enabled by default (see the

information until a logging profile specified with this command is

enabled with the

Based on the default settings used in RFC 3014, a notification log can

contain up to 256 entries, and the entry aging time is 1440 minutes.

Information recorded in a notification log, and the entry aging time can

only be configured using SNMP from a network management station.

When a trap host is created with the

default notify filter will be created as shown in the example under the

show snmp notify-filter

This example first creates an entry for a remote host, and then instructs

the switch to record this device as the remote host for the specified

notification log.

Console(config)#snmp-server host 10.1.19.23 batman

Console(config)#snmp-server notify-filter A1 remote 10.1.19.23

This command shows the operational status of configured notification logs.

Privileged Exec

Console#sh nlm oper-status

Filter Name: A1

Oper-Status: Operational

Filter Name: A2

Oper-Status: Operational

command), but will not start recording

snmp-server host

Show Quick Links

Chapters

Table of Contents