To configure LACP parameters for group members:
Click Interface, Trunk, Dynamic.
1.
Select Configure Aggregation Port from the Step list.
2.
Select Configure from the Action list.
3.
Click Actor or Partner.
4.
Configure the required settings.
5.
Click Apply.
6.
Figure 45: Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
Click Interface, Trunk, Dynamic.
1.
Select Configure Trunk from the Step List.
2.
Select Show Member from the Action List.
3.
Select a Trunk.
4.
Figure 46: Showing Members of a Dynamic Trunk
– 141 –
| Interface Configuration
C
5
HAPTER
Trunk Configuration