Automatic Operation Code Upgrade - Edge-Core ES3510MA Management Manual

Figure 10: Displaying System Files
Use the System > File (Automatic Operation Code Upgrade) page to
A
UTOMATIC
automatically download an operation code file when a file newer than the
O C
PERATION ODE
currently installed one is discovered on the file server. After the file is
U
PGRADE
transferred from the server and successfully written to the file system, it is
automatically set as the startup file, and the switch is rebooted.
CLI R
◆
◆
U
SAGE
◆
◆
◆
◆
◆
◆
◆
EFERENCES
"upgrade opcode auto" on page 517
"upgrade opcode path" on page 518
G
UIDELINES
If this feature is enabled, the switch searches the defined URL once
during the bootup sequence.
FTP (port 21) and TFTP (port 69) are both supported. Note that the
TCP/UDP port bindings cannot be modified to support servers listening
on non-standard ports.
The host portion of the upgrade file location URL must be a valid IPv4
IP address. DNS host names are not recognized. Valid IP addresses
consist of four numbers, 0 to 255, separated by periods.
The path to the directory must also be defined. If the file is stored in
the root directory for the FTP/TFTP service, then use the "/" to indicate
this (e.g., ftp://192.168.0.1/).
The file name must not be included in the upgrade file location URL.
The file name of the code stored on the remote server must be
es3510ma.bix (using upper case and lower case letters exactly as
indicated here). Enter the file name for other switches described in this
manual exactly as shown on the web interface.
The FTP connection is made with PASV mode enabled. PASV mode is
needed to traverse some fire walls, even if FTP traffic is not blocked.
PASV mode cannot be disabled.
The switch-based search function is case-insensitive in that it will
accept a file name in upper or lower case (i.e., the switch will accept
ES3510MA.BIX from the server even though ES3510MA.bix was
– 99 –
| Basic Management Tasks
C 4
HAPTER
Managing System Files