Edge-Core ES3510MA Management Manual page 139

Configuring LACP settings for a port only applies to its administrative
N :
OTE
state, not its operational state, and will only take effect the next time an
aggregate link is established with that port.
Configuring the port partner sets the remote side of an aggregate
N :
OTE
link; i.e., the ports on the attached device. The command attributes have
the same meaning as those used for the port actor.
W I
EB NTERFACE
To configure the admin key for a dynamic trunk:
Click Interface, Trunk, Dynamic.
1.
Select Configure Aggregator from the Step list.
2.
Set the Admin Key for the required LACP group.
3.
Click Apply.
4.
Figure 43: Configuring the LACP Aggregator Admin Key
– 139 –
| Interface Configuration
C 5
HAPTER
Trunk Configuration