Mvr Vlan Group - Edge-Core ES3510MA-DC Management Manual

| Multicast Filtering Commands
C 38
HAPTER
Multicast VLAN Registration

mvr vlan group

This command statically binds a multicast group to a port which will receive
long-term multicast streams associated with a stable set of hosts. Use the
no form to restore the default settings.
S
YNTAX
[no] mvr vlan vlan-id group ip-address
vlan-id - Receiver VLAN to which the specified multicast traffic is
flooded. (Range: 1-4093)
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast
traffic from the IP address specified for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
D S
EFAULT ETTING
No receiver port is a member of any configured multicast group.
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
◆ Multicast groups can be statically assigned to a receiver port using this
command.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for
◆
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
Only IGMP version 2 or 3 hosts can issue multicast join or leave
◆
messages. If MVR must be configured for an IGMP version 1 host, the
multicast groups must be statically assigned using the mvr vlan group
command.
E
XAMPLE
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/7
Console(config-if)#mvr type receiver
Console(config-if)#mvr vlan 3 group 225.0.0.5
Console(config-if)#
– 928 –