Removing An Options Board - Tait TM9100 Service Manual

The radio may be fitted with an options board in the lid assembly, which
Removing an
Options Board
may or may not have an external options connector fitted in a provision in
(Optional)
the lid assembly.
The circled numbers in this section refer to the items in
1.
2.
3.
Reassembly is carried out in reverse order of the disassembly.
Figure 5.5
130 Disassembly and Reassembly
If an external options connector is fitted:
Undo the two screws
(if fitted).
Undo the two D-range screwlock fasteners
Undo up to nine screws
E
lid assembly .
If an external options connector is fitted, a foam seal for the D-range
f
connector is fitted to the inside of the lid. Remove the foam seal
only if it is damaged.

Removing an options board

d
3/16 inch (5mm)
8lb·in (0.9N·m)
b
c
e
f
g
h
Torx T10
17lb·in (1.9N·m)
B
screw 4-40x3/15 (x2)
C
protective rubber cap
D
D-range screwlock fastener 4-40 (x2)
E
lid assembly
b
and remove the protective rubber cap
d
h
and remove the options board
F
foam seal for D-range connector
G
options board (example)
H
screw M3x10, self-tapping (x9)
© Tait Electronics Limited August 2005
Figure 5.5.
c
.
G
from the
3614z_01
TM9100 Service Manual