Installing The Options Extender Board - Tait TM8100 mobiles Service Manual

19.2

Installing the Options Extender Board

19.2.1 Parts Required
19.2.2 Installation Procedure
TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
The following table describes the parts required to install an options extender
board in a radio. The parts marked with an asterisk ( * ) are not shown in
Figure 19.2 and are used to connect to the radio's external options connector.
Table 19.2 Parts required for installation
Quantity Internal Part Number
1 362-01111-XX
1 362-01108-XX
2 347-00011-00
2 354-01043-00
4 349-02062-00
1 240-00032-00
*
1 240-06010-29
*
1. Contact Technical Support for the exact IPN.
1. Disassemble the radio in order to gain access to the options cavity.
For detailed disassembly instructions, refer to
Reassembly" on page
Refer to the diagram on the following page and the instructions below.
2. Remove the top cover and lid
options cavity.
3. Remove the external options connector bung
4. On the inside of the radio lid place the foam seal
options connector cavity
5. With the top side of the options extender board
lid, guide the external options connector
on the options extender board) into the external options connector
cavity.
6. Screw the external options connector to the radio lid using the two
screw-lock fasteners
Tighten the fasteners to a torque of 0.9N·m (8lbf·in).
Important
The external options connector screw-lock fasteners must
be tightened correctly before screwing the options extender
board onto the mounting posts
TMAA01-05 and TMAA01-07 Options Extender Boards
Description
1
foam seal
a
cover seal
4-40x3/16 screws
screw-lock fasteners
M3x8 screws
D-range plug
D-range hood
135.
b
from the radio to access the
e
.
h
.
Figure 19.2
Reference
d
1!
1@
h
j
—
—
"Disassembly and
c
, if it is fitted.
d
over the external
f
facing the radio
g
(the D-range connector
i
.
499