Description; Mechanical Design - Tait TM9100 Service Manual

2

Description

This section describes the mechanical design and architecture of the radio,
explains the operation of the transceiver and the control head, and gives
pinouts of the radio connectors.
2.1

Mechanical Design

The radio consists of the following main components:
Overview
Figure 2.1
The control head
where a seal
connects the control head to the radio body. Two dot-dash-dot marks at the
bottom of the radio body indicate the positions where a screwdriver is
applied to separate the control head from the radio body.
TM9100 Service Manual
© Tait Electronics Limited August 2005
B
control head
C
radio body
Components of the radio
B
B
clips firmly to the front face of the radio body
E
provides IP54 class protection. A control-head loom
C
D
E
3068z_01
C
,
D
Description 23