5.2
Disassembling the Radio Body
Disassemble only as much as necessary to replace the defective parts.
For reassembly instructions, refer to
page
1.
Removing the Cover
2.
3.
Figure 5.2
TM9100 Service Manual
© Tait Electronics Limited August 2005
131.
At the upper edge of the lower screw bosses on both sides of the radio
body, insert a 1/8 inch (3mm) flat-bladed screwdriver.
Push the screwdriver under the cover towards the upper screw boss to
release the cover from the upper screw boss.
Remove the cover.
Removing the cover
"Reassembling the Radio Body" on
insertion
point
lower
screw boss
cover
Disassembly and Reassembly
upper
screw boss
125