Installation; Installing The Microphone; Installing The Microphone Clip - Tait TM9100 Service Manual

9.
16.2

Installation

16.2.1

Installing the Microphone

Important
1.
Important
2.
3.
4.
Figure 16.1
16.2.2

Installing the Microphone Clip

Install the microphone clip in the most convenient location for the radio
user. It must be within easy reach of the user, but in such a position that the
microphone PTT key cannot be inadvertently activated or jammed on.
TM9100 Service Manual
© Tait Electronics Limited August 2005
Speak clearly into the microphone and release the PTT key when you
have finished talking.
The keypad microphone grommet must be installed when-
ever the microphone is plugged into the microphone
socket. When installed, the grommet has two functions:
to prevent damage to the microphone socket when
there is movement of the microphone cord, and
to ensure that the control head is sealed against water,
dust and other environmental hazards.
Make sure the radio is turned off, then plug the keypad microphone
cord into the microphone socket on the radio control head.
The radio will only recognize the presence of the keypad
microphone when the radio is powered on, so that if the
microphone is plugged in after the radio has been powered
on, it will not recognize the keypad microphone. Also, if
the keypad microphone is plugged in on power up but is
later unplugged, then plugged back in, the radio will not
recognize it again until the next power cycle.
Slide the microphone grommet along the microphone cord and push
two adjacent corners of the grommet into the microphone socket
cavity.
Squeeze the grommet and push the remaining corners into position.
Check that the grommet is seated correctly in the cavity.
Correct keypad microphone grommet seating
microphone
grommet
control head
TMAA02-08 Keypad Microphone 433