Handset Installation; Connecting The Handset To The Radio - Tait TM9100 Service Manual

Table 20.1 Handset PCB connector wiring
b
c
20.1.2

Handset Installation

1.
2.
3.
4.
20.1.3

Connecting the Handset to the Radio

Important
1.
2.
3.
4.
450 TMAA10-02 Handset
d e f g h
Press the pushbutton and remove the handset from the locking cradle.
Disassemble the locking cradle by removing the four locking cradle
screws.
Screw the handset mounting plate to the required mounting surface.
Note that mounting screws are not provided in this kit.
Clamp the top part of the locking cradle onto the mounting plate,
and secure it with the four locking cradle screws.
The handset microphone grommet must be installed when-
ever the handset to radio cord is plugged into the microphone
socket. When installed, the grommet has two functions:
to prevent damage to the microphone socket when there
is movement of the microphone cord, and
to ensure that the control head is sealed against water,
dust and other environmental hazards.
Plug the radio to microphone cord into the microphone socket on
the radio control head.
Slide the grommet along the cord and push two adjacent corners of the
grommet into the microphone socket cavity.
Squeeze the grommet and push the remaining corners into position.
Check that the grommet is seated correctly in the cavity.
Handset PCB
Colour Reference
Connector
2 white
or violet
3 blue
8 brown
9 yellow
10 green
TM9100 Service Manual
© Tait Electronics Limited August 2005
d
e
f
g
h