10.5
Faulty Radio Mute
If the radio mute is faulty, the calibration settings are suspect. There are three
Introduction
tasks:
The programming application is required for
application for
First use the programming application to determine the type of muting
Task 14 —
Determine Type of
selected.
Muting Selected
1.
2.
3.
4.
TM9100 Service Manual
© Tait Electronics Limited August 2005
Task
14: determine type of muting selected
Task
15: noise muting selected
Task
16: RSSI muting selected
Task 15
and
In the programming application click the "Basic Settings" page under
the "Channel Profiles" heading.
Click the "General Settings" tab.
Check the setting in the "Squelch Detect Type" field. Ensure that the
setting is what the Customer expects.
If the setting is "Noise Level", implying that noise muting is selected,
go to
Task
15. If the setting is "Signal Strength", implying that RSSI
muting is selected, go to
Task
14, and the calibration
Task
16.
Task
16.
Receiver Fault Finding
239