Installing An Enhanced Remote Kit; Installation - Tait TM9100 Service Manual

23

Installing an Enhanced Remote Kit

The control head of a graphical-display radio can be installed remotely from
the radio body. The diagram below shows the parts used for this installation.
(includes remote U-bracket)
Note
23.1

Installation

Warning!!
Caution
Important
Note
The circled numbers in the following sections refer to the items in
on page
TM9100 Service Manual
© Tait Electronics Limited August 2005
control-head interface
remote U-bracket
TMAA03-03 remote TMAA04-01 remote cable
control-head back
Although the torso interface is similar in appearance to the dual-
RJ45 on the telemetry radio, the control head on the telemetry
radio cannot be used for remote installation.
Mount the remote U-bracket with the remote
control-head assembly and the U-bracket with
the radio body securely. These units must not
break loose in the event of a collision. Unse-
cured radio units are dangerous to the
vehicle occupants.
Observe the installation warnings and safety regula-
tions in the installation procedures of the radio.
This equipment contains devices which are susceptible to
damage from static discharges. Refer to
on page 103
Torx T10 and T20 screwdrivers are required for most of the screws
in this installation.
462.
TMAC34-0T (TM8200) or
TMAC34-1T(TM9100)
for more information.
Installing an Enhanced Remote Kit
torso interface
"ESD Precautions"
Figure 23.1
461