Tait TM9100 Service Manual page 136

7.
8.
9.
10.
11.
Important
12.
136 Disassembly and Reassembly
Unscrew the four screws
Pull the concealed microphone
removing the control head-board
from the pads on the control-head board (refer to
H
Remove the light pipes
J
The space-frame clips into three clips of the front panel.
Unclip the spaceframe and remove it along with the two seals
G
Check the seals and replace them, if necessary.
1!
Remove the speaker and speaker clamp
When fitting the speaker and the speaker clamp, observe the
orientation of the speaker terminals. Make sure that the
larger of the three legs of the speaker clamp is placed
between the two clips of the front panel assembly as shown
in Figure 5.8 on page
Remove the LCD assembly
1$
.
E
and remove the control-head board
1%
capsule out of its rubber seal when
F
. If necessary, unsolder the leads
I
and .
1)
.
135.
1@ 1#
, main keypad , and power keypad
© Tait Electronics Limited August 2005
F
.
Figure 5.8).
G
.
TM9100 Service Manual