Disassembling And Reassembling The Control Head; Speaker Orientation And Connectors Of The Control-Head Board - Tait TM9100 Service Manual

5.4

Disassembling and Reassembling the Control Head

Disassemble only as much as necessary to replace the defective parts.
Reassembly is carried out in reverse order of the disassembly.
The circled numbers in this section refer to the items in
page
The connectors of the control-head board and the orientation of the speaker
and speaker clamp are illustrated in
1.
2.
3.
4.
5.
6.
Figure 5.8

Speaker orientation and connectors of the control-head board

legs of the
speaker clamp
speaker terminals
TM9100 Service Manual
© Tait Electronics Limited August 2005
137.
With your fingers, pull off the volume control knob
Do not use any tools as this might cause damage.
Unscrew the two screws
Disconnect the control-head loom
If an optional circuit board is fitted, unplug it from the control-head
F
board (refer to Figure
Note whether the speaker is connected or disconnected. If it is
connected, disconnect the speaker cable from the speaker connector
of the control-head board
must be returned to the customer in its original configuration.
Release the lock of the LCD connector and unplug the loom of the
1@
LCD assembly (refer to
through a slot in the space-frame
pads for leads of
concealed microphone
connector for speaker
Figure 5.8.
B
and remove the adaptor flange
D
.
5.8).
F
(refer to Figure 5.8). Note that the radio
Figure 5.8). Note that the loom runs
J
.
connector for connectors for
loom of LCD assembly optional circuit board
connector for
control-head loom
Disassembly and Reassembly
Figure 5.9 on
1&
.
C
.
3470z_01
135