Closing The Radio Body; Pad Top Can On The Top Side Of The Main Board - Tait TM9100 Service Manual

5.
Figure 5.7
6.
7.
8.
9.
The circled number in this section refer to the items in
Closing the
Radio Body
page
1.
2.
3.
4.
5.
6.
134 Disassembly and Reassembly
While pressing down firmly on the diagonal edge of the
(refer to Figure 5.7), use a Torx T20 torque-driver to tighten the two
I
screws to 22lb·in (2.5N
is seated correctly on the bosses for the five internal screws

PAD TOP can on the top side of the main board

PAD TOP can
Clean off any excess thermal paste on the heat-transfer block.
Screw in the five screws
possible. Use a Torx T10 torque-driver to tighten the screws to
17lbf in (1.9N m).
· ·
Fit the RF connector seal
around its entire periphery.
If an auxiliary connector bung
127.
If an internal options board is fitted inside the lid, connect the loom
to the internal options connector.
Inspect the main seal in the lid for damage, and replace if necessary.
D
Place the lid assembly
Use a Torx T20 torque-driver to tighten the four screws
(2.5N m).
·
b
Slide the cover over the radio body and snap holes in the side of
the cover over the screw bosses.
Inspect the control-head seal for damage, and replace if necessary.
m). This will ensure that the main board
·
E
through the main board by hand as far as
j
. Ensure that the seal is properly seated
h
was fitted, fit the bung.
G
on the chassis .
© Tait Electronics Limited August 2005
can
PAD TOP
E
.
Figure 5.3 on
c
to 22lbf in
·
TM9100 Service Manual