Table of Contents
Advertisement
6
5
4
1. Ensure the power is disconnected from the lamp power supply (LPS).
2. Loosen three screws to remove the rear lens-side cover.
3. Connect the LPS communication cables:
a. Connect one end of the RS232 cable to the lower port on the LPS labeled RS232.
b. Connect one end of the Interlock cable to the upper port on the LPS labeled Interlock.
c. Connect the projector end of the cable to the port labeled RS232, located on the
underside of the projector chassis.
d. Connect the projector end of the Interlock cable to the port labeled Interlock, located
on the underside of the projector chassis.
4. Connect the LPS lamp leads:
a. Route the positive (+) cable through the upper strain relief in the LPS cover.
b. Route the negative (-) cable through the lower strain relief in the LPS cover.
c. Connect the positive (+) and negative (-) lamp leads to the terminals on the LPS.
d. Tighten the strain reliefs.
e. Pull the spring plunger to open the igniter door. The door can also be lifted off the hinges
to remove it completely.
f. Route the positive (+) and negative (-) leads from the LPS through the two strain reliefs
in the projector baseplate.
Mirage 4K35 User Manual
020-101377-03 Rev. 1 (07-2015)
3
1
2
Installation and Setup
27
Advertisement
Table of Contents
