Position The Projector - Christie Mirage 4K35 User Manual

ID Item
C Main LPS breaker
D Projector Interlock and
Communication Connections
E DC lamp power cables
F Lamp breaker
G Outlet breaker
H Power phase indicator lights
I LPS power inlet

Position the projector

1. Position the projector at an appropriate throw distance (projector-to-screen distance) and
vertical position. Ideally, center the projector with the screen. If space is limited, aim the
projector slightly off-center. This increases side keystoning, but reduces the horizontal lens
offset required.
Keep the projector lens as perpendicular to the screen as possible, even if significantly above
the screen center. When a particularly short throw distance combines with a wide screen, you
may have to forfeit some aim and stay more perpendicular to the screen. In such cases, some
lens offset can reduce the keystone distortion.
2. Position the lamp power supply (LPS) so its cables reach the lens side of the projector.
3. If using an optional rack stand (P/N: 108-282101-02), assemble the rack stand using the
instructions provided with the rack stand. Use the hold down clamp (P/N: 116-100101-01)
when securing the projector to the rack stand.
Mirage 4K35 User Manual
020-101377-03 Rev. 1 (07-2015)
Description
Acts as a power switch, protecting the LPS against over-current conditions
of 50A or more.
Provides communication between the projector and the lamp power supply.
Carries power from the LPS to the projection lamp.
Acts as a power switch, protecting the LPS against over-current conditions
of 50A or more.
Acts as a power switch, protecting the extractor and the projector
electronics against over-current conditions of 15A or more.
Indicates the power on each of the three phases.
Supplies power to the LPS. This connection must be professionally wired,
according to local regulations.
90°
Installation and Setup
≠90°
24