Connecting External Exhaust Ducting (Optional); Removing The Projector Shroud (Optional) - Christie Roadie 4K35 Quick Start Manual

High-brightness projection system

Hide thumbs Also See for Roadie 4K35:

Table of Contents

4. Fasten the end of the touch panel controller safety strap attached to the ball joint on the

projector to the touch panel controller ball joint using the M4 screw removed in the previous

step.

The touch panel controller safety strap comes installed on the projector ball point.

5. Connect the cable from the touch panel controller to the connector on the rear panel of the

projector.

6. Adjust the touch panel controller angle for optimal viewing, then tighten the mounting arm

lock securely so that the touch panel controller is held in place at the required location.

Connecting external exhaust ducting (optional)

Connect exhaust ducting to the low profile extractor located on top of the rear of the projector to

extract hot air from the lamp compartment and exhaust it out of the rear of the projector.

External exhaust ducting can be connected to remove hot air from the projector by installing the

optional Ducted Exhaust Kit (P/N: 113-107109-XX).

The lens side shroud must be removed to gain access to the lens. The other shroud must be removed

when connecting the AC power cord into the front face of the projector.

Warning! Failure to comply with the following could result in death or serious injury.

•

Do not install the shroud for overhead installations.

1. Use finger pressure to push down on the shroud clips located at the top and bottom of the

shroud as shown by the arrows.

2. Carefully slide the shroud sideways and forward away from the lens mount and lens.

Roadie 4K35 Quick Start Guide

020-101671-04 Rev. 1 (01-2016)

Installation and Setup

Table of Contents