Remove The Shroud - Christie CP42LH User Manual

3. Install a lens cap.
4. Turn the lens clamp to the open position on the motorized lens mount (MLM) (A).
5. Pull the lens out of the lens mount and install a small lens cap on the rear of the lens.
6. Add the new lens.
See Install the lens
7. To calibrate the lens motors, on the TPC tap Menu > Configuration > Calibrate Lens
Motors.

Remove the shroud

1. Use finger pressure to push down on the shroud clips, as shown by the red arrows.
2. Carefully slide the shroud sideways and forward away from the lens mount, as shown by the
black arrows.
3. Place the shroud on a clean surface to prevent scratches.
CP42LH User Guide
020-101363-03 Rev. 1 (08-2016)
on page 72.
1
2
Maintenance
A
71