4. Tighten the screw to secure the harness in place.
Ensure the wire insulation is not crimped under the screw.
5. Slide the selector switch to the 200V location.
6. Re-attach the front panel.
Configuring ballast settings for 400 VAC operation
1. Unplug the LPS from power.
2. Remove the front panel using a Philips screwdriver.
3. Insert the convenience outlet harness (black) wire into the second position on the terminal
block.
4. Tighten the screw to secure the harness in place.
Ensure the wire insulation is not crimped under the screw.
Mirage 4K35 User Manual
020-101377-03 Rev. 1 (07-2015)
Installation and Setup
30