Maintenance Part List - Toshiba e-STUDIO2330C Service Handbook

5.9

Maintenance Part List

The parts used for the maintenance of this equipment are as follows.
No. Item
1 Cleaning brush
2 Doctor blade cleaning jig
3 Wire holder jig
4 Developer material nozzle
5 Doctor-sleeve jig
6 Belt tension jig
7 Separation plate gap jig
8 Drum bag
9 Download jig (DLM board)
10 ROM
11 Download jig-2 (6 Flash ROMs)
12 ROM writer adapter (For 1881)
13 ROM writer adapter (For 1931)
14 Harness jig
*: Part list <P-I> represents the page item in "e-STUDIO2330C/2820C/2830C/3520C/3530C/
4520C Service Parts List".
No.1-13: Refer to "e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C Service Parts List"
No.14 : Refer to "MJ-1101 Service Parts List"
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
PREVENTIVE MAINTENANCE (PM)
Purpose
Cleaning inside of the equipment
Cleaning the doctor blade
Fixing the wire at the assembly of the carriage wire
Pouring the developer material (attached to the
developer bottle)
Measuring the gap between the development sleeve
and the doctor blade
Adjusting the belt tension at the installation of the
scan motor
Measuring the gap between the separation plate and
the fuser belt
Storing the drum
Updating the scanner/options ROM
Installing the DLM board
Updating the system/engine/scanner ROM
Writing the data of PWA-DWNLD-350-JIG2
Writing the data of PWA-DWNLD-350-JIG2
Updating the converter PC board
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
5 - 38
Parts list
<P-I>*
101-2
101-3
101-4
101-5
101-6
101-7
101-8
101-10
102-1
102-10
102-2
102-4
102-5
21-3