Toshiba e-STUDIO2330C Service Handbook page 286

Error code Classification
CB90 Finisher related
service call
CBA0
CBB0
CBC0
CBD0
CBE0
CBF0
CC00
CC10
CC20
CC30
CC31
CC40
CC41
CC50 Finisher related
service call
CC51
CC52
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
Contents
Paper pushing plate motor abnormality: Paper
pushing plate motor is not rotating or paper pushing
plate is not moving normally. [MJ-1030]
Stitch motor (front) abnormality: Stitch motor (front)
is not rotating or rotary cam is not moving normally.
[MJ-1030]
Stitch motor (rear) abnormality: Stitch motor (rear)
is not rotating or rotary cam is not moving normally.
[MJ-1030]
Alignment motor abnormality: Alignment motor is
not rotating or aligning plate is not moving normally.
[MJ-1030]
Guide motor abnormality: Guide motor is not
rotating or guide is not moving normally. [MJ-1030]
Paper folding motor abnormality: Paper folding
motor or paper folding roller is not rotating normally.
[MJ-1030]
Paper positioning plate motor abnormality: Paper
positioning plate motor is not rotating or paper
positioning plate is not moving normally. [MJ-1030]
Sensor connector abnormality: Connector of guide
home position sensor, paper pushing plate home
position sensor or paper pushing plate top position
sensor is disconnected. [MJ-1030]
Micro switch abnormality: With all covers closed,
inlet door switch, delivery door switch or front cover
switch is open. [MJ-1030]
Communication error between finisher and saddle
stitcher: Communication error between finisher
controller PC board and saddle stitcher controller
board [MJ-1030]
Stack transport motor abnormality: The stack
transport motor is not rotating or the stack transport
belt is not moving normally. [MJ-1101]
Stack delivery motor abnormality: The stack
delivery motor is not rotating normally. [MJ-1031]
Transport motor abnormality: The transport motor is
not rotating or the stack transport roller -1 and -2 is
not rotating normally. [MJ-1101]
Swing motor abnormality: Swing motor is not
rotating or swing unit is not moving normally. [MJ-
1030]
Paper holder cam home position abnormality: The
paper holder cam is not at the home position. [MJ-
1101]
Horizontal registration motor abnormality:
Horizontal registration motor is not rotating or
puncher is not shifting normally. [MJ-1030 (when
MJ-6004 is installed)]
Sideways adjustment motor (M2) abnormality:
Sideways adjustment motor is not rotating or
puncher is not shifting normally. [MJ-1101 (when
MJ-6101 is installed)]
Skew adjustment motor (M1) abnormality: Skew
adjustment motor is not rotating or puncher is not
shifting normally. [MJ-1101 (when MJ-6101 is
installed)]
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
6 - 10
Troubleshooting
P. 6-75
P. 6-75
P. 6-75
P. 6-75
P. 6-75
P. 6-76
P. 6-76
P. 6-76
P. 6-77
P. 6-77
P. 6-77
P. 6-78
P. 6-78
P. 6-78
P. 6-79
P. 6-79
P. 6-80