Toshiba e-STUDIO2330C Service Handbook page 447

(6) Press the [START] button.
Updating starts and the processing status is displayed on the LCD screen.
Status display during update
MEP Firm Update ..........
(7) "Update Completed." is displayed at the bottom of the LCD screen after the updating is
completed properly.
Notes:
• "Update Failed." is displayed at the bottom of the LCD screen when the updating is not
completed properly. "Failed" appears next to the failed item on the status display. Even
though an update fails, do not turn the power OFF until other updates are finished. If "Update
Failed" appears at the bottom of the screen, turn OFF the power and then check the following
items. After confirming and clearing the problems, restart updating from the beginning.
- Do the USB media meet the conditions to be used for updating?
- Is the data file written properly on the USB media?
- Are the USB media installed properly?
- Do the USB media and equipment operate properly?
• When an error occurred and the update failed, "Update Failed" or "Failed" appears on the
screen and an error code appears next to the message. The content of each error code is
shown below.
Error number
Board Error
I01
Parameter Error
I02
File Read Failed
I03
Temporary File Error
I04
I05 File Format Error
Memory Allocation Failed
I06
I00 Other error
(8) Press the [ON/OFF] button to shut down the equipment, and then remove the USB media.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Status display when update is completed
SROM Update MEP Firm Update ..........
Fig. 8-3
Imaging Acceleration Board update Error
Error message
8 - 19
Completed
Error content
The MEP board is not operating
properly.
The parameter for API function is
incorrect.
An error occurred during a file input
operation.
An error occurred during a temporary file
operation.
The format of the input file is incorrect.
An error occurred during the memory
allocation.
Other error
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
8