Toshiba e-STUDIO2330C Service Handbook page 405

(5) Remove 3 screws and pull out the filter
bracket.
Note:
Do not pull it out too strongly because the
harness is connected to it.
(6) Disconnect 5 connectors from the FIL board
and take off the filter bracket.
Note:
The connector connected to CN497 on the
FIL board can be disconnected on the relay
connector side.
(7) Remove 1 binding band.
(8) Remove 2 Faston terminals.
Note:
Be sure to use the correct harness (black or
white) when assembling.
(9) Remove 2 screws, release 2 locking
supports and take off the FIL board.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 7-21
Relay connector
Fig. 7-22
FIL board
Locking support
Fig. 7-23
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
REPLACEMENT OF PC BOARDS/HDD
7 - 9
Filter bracket
( CN497 )
binding band
White
Black
7