Toshiba e-STUDIO2330C Service Handbook page 58

[Digital key]
[0][5]
(Code)
[POWER]
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 14
[0][5]
[Digital key]
[POWER]
(Code)
Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode.
In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after it has
become ready state and then start up the adjustment mode again.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
SELF-DIAGNOSTIC MODE
[CANCEL]
[Digital key]
[START] [START]
(Sub code)
[CLEAR]
(Corrects value)
*[CANCEL] or [CLEAR]
* When the automatic adjustment ends abnormally, an error message is
displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
[Digital key]
[START]
(Sub code)
[ENTER] or [INTERRUPT]
(Value unchangeable)
[Digital key]
[START]
[START]
(Sub code)
[CLEAR]
(Corrects value)
Automatic
Stores value
adjustment
Value
[START]
displayed
[UP] or [DOWN]
(Adjust a value)
[INTERRUPT]
Stores value
[CANCEL]
(Corrects value)
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
2 - 32
[FAX]
[ENTER]
[START]
in RAM
(Test copy)
[POWER]
[START]
OFF/ON
(Exit)
[ENTER]
[FAX]
[POWER]
or
OFF/ON
[START]
(Test copy)
in RAM
[POWER]
OFF/ON
(Exit)
(Exit)