Toshiba e-STUDIO2330C Service Handbook page 438

Notes:
• "Update Failed." is displayed at the bottom of the LCD screen when the updating is not
completed properly. "Failed" appears next to the failed item on the status display. Even
though an update fails, do not turn the power OFF until other updates are finished.If "Update
Failed" appears at the bottom of the screen, turn OFF the power and then check the following
items. After confirming and clearing the problems, restart updating from the beginning.
- Do the USB media meet the conditions to be used for updating?
- Is the data file written properly on the USB media?
- Are the USB media installed properly?
- Do the USB media and equipment operate properly?
• When an error occurred and the update failed, "Update Failed" or "Failed" appears on the
screen and an error code appears next to the message. The content of each error code is
shown below.
Error number
O01
O02
O03
O04
O05
O06
Error number
H01
H02
H03
H00
Error number
M01
M02
M03
M04
M05
M06
M07
M08
M09
M10
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
OS update Error
FROM writing failed
FROM verification error
File operation error
SRAM flag set error
Electronic key data backup error
Device error
HDD update Error
File creation error
File decompression error
Partition mount error
Other errors
Engine update Error
Error message
Time out
(When the download is requested)
Time out
(When the download is written)
Time out
(When the download is finished)
Reception failed
(When the download is requested)
Deletion error
(When the download is written)
Writing error
(When the download is written)
Checksum error
(When the download is finished)
Reception status code abnormality
(When the download is requested)
Reception status code abnormality
(When the download is written)
Reception status code abnormality
(When the download is finished)
Error content
Error content
Communication timeout
(When the download is requested)
Communication timeout
(When the download is written)
Communication timeout
(When the download is finished)
Downloading request was denied.
(When the download is requested)
Deletion error
(When the download is written)
Writing error
(When the download is written)
Checksum error
(When the download is finished)
Reception status code abnormality
(When the download is requested)
Reception status code abnormality
(When the download is written)
Reception status code abnormality
(When the download is finished)
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
8 - 10
Error content