Toshiba e-STUDIO2330C Service Handbook page 311

[E450] LCF side cover open jam
1. Close the LCF side cover if it is opened. Remove if there is any paper before closing it.
2. Is the LCF side cover opening/closing switch working? (Perform the input check: 03-[FAX]OFF/
[0]/[D])
3. Check if the connector CN349 on the LGC board is disconnected from the LCF side cover
opening/closing switch or the harnesses are open circuited. Check if the connectors CN1 and
CN6 on the LCF board are disconnected. Correct if any.
4. Replace the LCF side cover opening/closing switch.
5. Replace the LCF board.
6. Replace the LGC board.
[E480] Bridge unit open jam
1. Close the bridge unit if it is opened. Remove if there is any paper before closing it.
2. Is the bridge unit cover opening/closing detection switch working? (Perform the input check: 03-
[FAX]OFF/[5]/[E])
3. Check if the connector CN334 on the LGC board is disconnected from the bridge unit cover
opening/closing detection switch or the harnesses are open circuited. Correct if any.
4. Replace the bridge unit cover opening/closing detection switch.
5. Replace the LGC board.
[E4A0] Waste toner cover open jam
1. Close the waste toner cover if it is opened. Remove if there is any paper before closing it.
2. Is the waste toner cover open/close detection switch working? (Perform the input check: 03-
[FAX]OFF/[1]/[H])
3. Check if the connector CN359 on the LGC board is disconnected from the waste toner cover
open/close detection switch or the harnesses are open circuited. Correct if any.
4. Replace the waste toner cover open/close detection switch.
5. Replace the LGC board.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
6 - 35
6