Configuring Session Protection - Cisco CRS Configuration Manual

Implementing MPLS Label Distribution Protocol
Command or Action
Related Topics
Local Label Allocation Control, on page 16
Configuring Local Label Allocation Control: Example, on page 82

Configuring Session Protection

Perform this task to configure LDP session protection.
By default, there is no protection is done for link sessions by means of targeted hellos.
SUMMARY STEPS
1. configure
2. mpls ldp
3. session protection [ for peer-acl ] [ duration seconds ]
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 mpls ldp
Example:
RP/0/RP0/CPU0:router(config)# mpls ldp
Purpose
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters the MPLS LDP configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring Session Protection
49