Configuring The Mpls Controller; Configuring Clock Sources - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Configuring the MPLS Controller

mgx8850a.7.PXM.a> dsppnni-node
node index: 1
Level...............
Restricted transit..
Branching restricted
Admin status........
Non-transit for PGL election..
Node id...............56:160:47.00918100000000001a531c2a.00001a531c2a.01
ATM address...........47.00918100000000001a531c2a.00001a531c2a.01
Peer group id.........56:47.00.9181.0000.0100.0000.0000.00
mgx8850a.7.PXM.a> dspspvcprfx
SPVC Node Prefix: 47.00918100000100001a531c2a
In the example above, the node ATM address does not conform to the peer group ID or the SPVC prefix,
so it must be advertised in addition to the SPVC prefix.
Configuring the MPLS Controller
The MPLS controller manages MPLS communications through the switch. Typically, the MPLS
controller is used with a PNNI controller. Both MPLS and PNNI controllers can be used on the same line.
The MPLS label switch controller (LSC) function is not supported on Cisco MGX 8830 and
Note
Cisco MGX 8850 (PXM1E) switches.
Note Before entering the following command, you must log in as a user with SUPER_GP privileges or higher.
To enable and configure the MPLS controller, enter the following command:
mgx8850a.7.PXM.a > addcontroller <cntrlrId> i <cntrlrType> <lslot> [cntrlrName]
Table 2-5
Tip Remember to include the i option, which identifies the controller as an internal controller.
To display the MPLS controller configuration, enter the dspcontrollers command:
mgx8850a.7.PXM.a > dspcontrollers

Configuring Clock Sources

The
Configuration,"
•
•
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
2-30
describes the parameters for the addcontroller command.
"Guidelines for Creating a Network Clock Source
introduces two clock source configuration options:
manual
Network Clock Distribution Protocol (NCDP)
node name: 8850_LA
56 Lowest..............
off Complex node........
on
up Operational status..
off
Plan" section in
Chapter 2 Configuring General Switch Features
true
off
up
Chapter 1, "Preparing for
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004