Table of Contents
Advertisement
Quality of Service
Workflow to Configure QoS Settings
STEP 5
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
•
Remark IP Precedence—Check Enable to remark the IP precedence for
egress traffic on this port or LAG.
•
Remark DSCP—Check Enable to remark the DSCP value for egress traffic
on this port or LAG.
Click Apply. The Running Configuration is updated.
Configuring Bandwidth
Use the Bandwidth page to define two sets of values that determine how much
traffic the switch can receive and send.
The ingress rate limit is the number of bits per second that can be received from
the ingress interface. Excess bandwidth above this limit is discarded.
To enter bandwidth limitation:
Click Quality of Service > General > Bandwidth.
To edit the bandwidth limitation settings, select an interface and click Edit.
Enter the following information:
•
Interface—Select the type of interface and specific interface to be
configured.
•
Ingress Rate Limit—Check Enable to enable the ingress rate limit, which is
defined in the Ingress Rate Limit field below. Uncheck to disable this
feature.
•
Ingress Rate Limit—Enter the maximum amount of bandwidth allowed on
the interface.
•
Egress Shaping Rates—Check Enable to enable egress shaping on the
interface, which is defined in the following field. Uncheck to disable this
feature.
Click Apply. The bandwidth settings are modified, and the Running Configuration
is updated.
18
249
Advertisement
Table of Contents
