Static Wheel Balance Adjustment - Yamaha TDM850 1996 Service Manual

REAR WHEEL, BRAKE DISC AND DRIVEN SPROCKET
6. Inspect:
S Driven sprocket
More than 1/4 teeth a wear ! Replace
sprocket.
Bent teeth ! Replace sprocket.
b Correct
1 Roller
2 Sprocket
Driven sprocket replacement steps:
S Remove the self locknuts and driven sprocket.
S Clean the hub, especially on the surfaces in con-
tact with the sprocket, using a clean cloth.
S Install the new driven sprocket.
Driven sprocket:
60 Nm (6.0 mSkg)
NOTE:
Tighten the self locknuts in stage, using a criss-
cross pattern.

STATIC WHEEL BALANCE ADJUSTMENT

NOTE:
S After replacing the tire and/or rim, wheel balance
should be adjusted.
S Adjust the wheel balance with brake disc and
hub installed.
1. Adjust:
S Wheel balance
Refer to "FRONT WHEEL AND BRAKE
DISCS".
7-12
CHAS