REAR WHEEL, BRAKE DISC AND DRIVEN SPROCKET
INSPECTION
1. Inspect:
S Rear wheel axle
Refer to "FRONT WHEEL AND BRAKE DISC".
2. Measure:
S Wheel runout
Refer to "FRONT WHEEL AND BRAKE DISC".
3. Install:
S Wheel bearings
S Oil seals
S Collars
Refer to "FRONT WHEEL AND BRAKE DISC".
4. Measure:
S Brake disc deflection
Out of specification ! Inspect wheel runout.
If wheel runout is in good condition, replace the
brake disc(s).
NOTE:
Remove the brake caliper before inspecting the
brake disc deflection.
Maximum deflection:
0.15 mm
S Brake disc thickness
Out of specification ! Replace.
Minimum thickness:
4.5 mm
Measuring point 1 X 3 mm
5. Inspect:
S Clutch hub 1
Cracks /Damage ! Replace.
S Rubber dampers 2
Wear/Damage ! Replace.
7-11
CHAS