Tubular Swinging Arm; Removing And Installing Spacer Bushing For Tubular Swinging Arm; Replacing Left/Right Bearing Bushings For Tubular Swinging Arm - BMW C1 Repair Manual

Tubular swinging arm

– Remove drive swinging arm mounts.
Removing and installing spacer bushing for
tubular swinging arm
3
•
Remove bolt (1) for joint.
•
Remove tubular swinging arm (3).
•
Remove spacer bushing (2).
When installing:
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Lightly coat spacer bushing (2) with
Shell Retinax EP2.
e
Caution:
The projection of the link for the swinging-arm bear-
ing mount is wider on the right than on the left!
Take this into account when installing the link for
swinging-arm bearing mount!
Operating fluids:
Shell Retinax EP2
X
Tightening torques:
Bolt for joint.................................................. 73 Nm
Replacing left/right bearing bushings for tubular
swinging arm
– Remove spacer bushing.
00 8 574
1
2
•
Remove bearing bushings (arrow) on left and
C1460680
right with puller, BMW No. 00 8 572 and internal
puller (21/3), BMW No. 00 8 574.
When installing:
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Bolt for joint.................................................. 73 Nm
00 8 572
C1460690
46.47