Installing Swinging Arm - BMW K 1100 LT Repair Manual

Installing swinging arm

•
Slide swinging arm over drive shaft.
•
Lift drive shaft over the support surface in the
swinging fork and press forward swinging arm as
far as possible until gaiter snaps in position at the
gearbox neck.
•
Coat bearing pin of fixed bearing with
Optimoly TA
special tool
•
Install bracket (1) for line of electric side stand
switch.
X
Swinging arm fixed bearing ............................ 9 Nm
•
Coat bearing pin of loose bearing with
Optimoly TA, install, firmly tighten and secure
locknut.
X
Bearing pin of loose bearing
(clean thread + Loctite 270)............................ 7 Nm
Locknut ........................................................ 41 Nm
Downloaded from www.Manualslib.com
26 1 660
and install and firmly tighten with
BMW No. 26 1 660
1
Tightening torque:
Tightening torques:
manuals search engine
Installing footrest plates
•
Install left footrest plate.
•
[ABS]
•
Mount silencer.
X
Tightening torques:
Footrest plate to gearbox ............................ 15 Nm
Silencer to footrest plate ................................ 9 Nm
•
Install right footrest plate.
•
Carefully arrange all leads and hoses; ensure
they are not pinched.
•
[ABS] Note earth (ground) cable.
X
Tightening torques:
Footrest plate to gearbox ............................. 15 Nm
[ABS I] Support bracket,
pressure modulator ...................................... 17 Nm
LT330310
.
LT330390
Note earth (ground) cable.
33.21