BMW engine management system
(BMW-Motor-Steuerung, BMS)
Replacing BMS control unit
13 61 025
–
Open the seat.
–
Remove the backrest.
–
Remove the rear stowage compartment.
....................................................See Group 46
a
•
Disconnect plug (arrow) by pulling the red latch
up while pulling the plug to the right.
•
Remove fasteners (arrows) securing the BMS
control unit.
•
Remove the BMS control unit.
When installing:
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Fasteners for BMS control unit ....................... 5 Nm
Replacing starter motor
12 41 020
e
Caution:
Disconnect ground lead from battery and insulate.
•
Remove fasteners securing intake air silencer to
rear mudguard.
•
Remove fasteners securing rear mudguard.
C1120050
•
Unclip the breather hose for the intake air silenc-
er from the secondary swinging arm.
•
Remove the fasteners securing the air filter hous-
ing to the drive swinging arm.
•
Disconnect plus (+) and minus (-) cables (arrows)
from starter.
•
Push the intake air silencer up and to the right
and pull the cover for the rear mudguard over the
starter.
•
Pull the starter out of the guide.
L
Note:
Grease the pinion and oil the O-ring before reinstall-
ing.
C1120040
Operating fluids:
Pinion of starter motor........................... Shell HDX2
X
Tightening torques:
Starter motor to engine ................................ 10 Nm
C1120060
12.7