•
Remove the fastenings (arrows) for the holder.
•
Push the fuel tank down.
•
Raise the vehicle with the lifter far enough to al-
low the fuel tank to be lifted out to one side.
When installing:
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Make sure that the fuel-tank rests (foam rubber
pads) are correctly positioned.
Make sure there is clearance from the right-hand
tunnel panel.
X
Tightening torques:
Fuel tank holder to frame................................ 9 Nm
Holder for washing-fluid reservoir/ABS control unit
to frame.......................................................... 9 Nm
Replacing fuel filter
16 12 008
–
Open the seat.
–
Remove left service cover.
....................................................See Group 46
a
d
Warning:
Comply with safety precautions when handling or
working with fuel.
C1160070
•
Release the fastener (arrow).
13 3 010
•
Use hose clamps, BMW No. 13 3 010, to close
off fuel hoses (arrows).
•
Open hose clamp (1) with pliers,
BMW No. 17 5 500.
When installing:
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Note correct direction of flow through fuel filter (indi-
cated by white arrow).
Make sure the hose clamps are correctly posi-
tioned.
Make sure the hoses do not chaff.
X
Tightening torques:
Fastener for fuel filter...................................... 5 Nm
C1160080
17 5 500
1
13 3 010
C1160090
16.7