Replacing Ignition Trigger Cover; Replacing Alternator; Replacing Tdc Trigger - BMW C1 Repair Manual

Replacing ignition trigger
11 11 015
cover
– Remove the right rear side section.
•
Drain engine oil.
•
Remove fastener securing silencer to secondary
swinging arm.
•
Slacken fasteners securing exhaust to cylinder
head.
•
Swing silencer to the outside and secure in this
position.
•
Disconnect cables under rear side section from
ignition trigger and generator.
•
Remove 9 securing screws and lift off cover.
•
Remove stator.
When installing:
•
Always install a new seal.
•
Use 3 Bond 1209 to seal the rubber grommets of
cable glands.
Operating fluids:
Rubber grommet ............................... 3 Bond 1209
X
Tightening torques:
Cover to housing.......................................... 10 Nm

Replacing alternator

12 11 070
– Remove ignition trigger cover.
•
Remove fasteners (1).
•
Remove fasteners (arrows) and remove stator.

12 11 060 Replacing TDC trigger

•
Remove securing screws and remove ignition
trigger.
1
C1110190
11.25